Who owns what in a Plantation building
Plantation has a median build year of 1984 across 40,014 units, 45% single-family detached and 15% in buildings of fifty or more. That mid-1980s cohort is a particular moment in South Florida construction. Whole-house central air was by then standard rather than an upgrade, but the sizing of it was still generally a matter of experience and a rule of thumb per square foot rather than a calculated load. Houses of this era therefore carry systems that were often generous to begin with, on buildings that have since had windows, roofs and insulation improved, which makes them more generous still.
In any building held in units, the first question is not what is growing. It is which side of the unit boundary the water came from, because that decides who pays for all of it. A condominium unit is defined by a line written into the declaration, usually running along the unfinished surfaces of the perimeter walls, floor and ceiling. Everything beyond it is a common element the association maintains. That line is invisible and water crosses it constantly.
In older stock across this county the sources are almost all on the far side of your wall. Facade and window perimeter sealant that has had decades of salt and ultraviolet, letting driven rain into the wall assembly. Plumbing risers and stack vents in a chase shared between stacked units. Roof and balcony drainage arriving several floors below the failure. And the unit above, which is the commonest of all and the slowest to establish because it needs access nobody wants to give.
What decides responsibility is where the source sits, not where the damage appears. So the inspection in Plantation is built around tracing the path rather than documenting the stain: metering the wall and ceiling on a grid so the gradient shows the direction of travel, and thermal imaging to follow the cold path back towards the entry. We do not tell you what your declaration says, because that is a document for you and your lawyer. We tell you which side of the wall the water came from.
The commercial position in Plantation is the one published on every page of this site, because the rate card is not a Fort Lauderdale rate card. A flat price by property size, agreed before anyone drives out, with the accredited laboratory fee already inside it. It does not rise if the samples come back positive, nothing is added for the drive, and we take no payment of any kind from anyone who removes mold.

What Plantation itself changes
Where the water comes from
Central Broward sits between the coastal ridge and the drained western land and gets the ordinary version of both: no salt exposure to speak of, no barrier island facade problem, but a flat site, a shallow water table and the full 47.27 inches of wet season rain. What tends to distinguish a Plantation call is that there is often no dramatic water event at all in the history. The building simply runs damp, and the cause is on the mechanical side rather than the envelope.
Where it hides in these buildings
Mature tree canopy is a genuine factor in the older parts of this city, and it works in two directions. Shade keeps exterior wall surfaces cooler, which is good for cooling load and bad for the drying rate on a wall that gets wet. And leaf litter in gutters and valleys on a 1980s roof keeps water sitting where it was meant to run. Inside, the usual suspects are interior closets housing air handlers and the wall cavities immediately around them.
The cooling systems here
This is the town where the oversizing story is at its clearest, and it is the one where local community forums carry the complaint in its most recognisable form: a new system installed, and the symptoms of damp arriving within weeks. The Florida Solar Energy Center puts a worked figure on why. A house needing two tons that is given four is dehumidified worse by the larger machine despite twice the nameplate moisture capacity, because moisture removal does not reach rate until around three minutes into a cycle and the oversized unit has already satisfied the thermostat.