What the equipment in Pembroke Park can and cannot remove
Packaged units and split systems with duct frequently run through the floor cavity, which in this stock is the combination most likely to produce a problem. A duct in a wet floor void is surrounded by exactly the moisture it will condense, and where a joint has separated, the system is drawing air out of that void and delivering it to every room. Condensate drainage on these homes tends to be short, shallow and easily blocked.
The reason that matters is a gap between two numbers, both from the Florida Solar Energy Center at the University of Central Florida. Through the hot months, with cooling running, indoor relative humidity should not exceed 55% during the day on a regular basis. And the great majority of mold species need a material moisture content corresponding to a relative humidity of at least 70% to grow at all.
Note where that second number is measured. Not in the room. At the material. Air holds less moisture as it cools, so the film of air against a chilled surface sits at a far higher relative humidity than the room average. A wall at 68F with 78F room air at 55% is close to saturation at its own face, and it does not need a leak to get there. That is the mechanism behind almost every complaint where nobody can find a source.
So in Pembroke Park we read surface temperatures with an infrared thermometer alongside the room air, calculate the dew point of that air, and record the margin at every surface that has one worth recording. FSEC also give the point at which cooling alone stops being enough: sustained readings of 70 to 75% mean dehumidification rather than a colder thermostat, and turning the thermostat down at that stage chills the surfaces further and makes it worse.
The commercial position in Pembroke Park is the one published on every page of this site, because the rate card is not a Fort Lauderdale rate card. A flat price by property size, agreed before anyone drives out, with the accredited laboratory fee already inside it. It does not rise if the samples come back positive, nothing is added for the drive, and we take no payment of any kind from anyone who removes mold.

What Pembroke Park itself changes
The buildings in Pembroke Park
Pembroke Park is unlike anywhere else in Broward County: 53.4% of its 3,698 housing units are manufactured homes, against a county figure of 2.6%, at a 1978 median and with only 32% owner occupancy. That single statistic changes almost everything about how an inspection here is carried out. A manufactured home is a floor assembly raised above grade with a void beneath it, wrapped underneath with a belly board, and the moisture that matters most does not come through the walls or the roof. It comes up out of the ground.
Where the water comes from
Ground moisture is the mechanism. Bare earth under a raised floor evaporates continuously, and where the ground beneath a home has no vapour barrier or where that barrier has been torn during service work, that moisture rises into the floor void. The belly wrap that should keep it out of the insulation is routinely damaged by plumbing repairs, animals or age, and once it is open the insulation above it absorbs. The wet season adds to that rather than causing it.
Where it hides in these buildings
The underside is the inspection. Ground condition and any vapour barrier, the integrity of the belly wrap, the ventilation of the void, the condition of the floor insulation and the routing of any duct or plumbing run through it. That is not work that can be done from inside the home, and an assessment of a manufactured home that skips it is describing the symptoms. Interior readings still matter and they are read in the light of what is underneath.