What the equipment in Davie can and cannot remove
Split systems on the site-built stock, often with long duct runs to reach the ends of a sprawling single-storey plan, and packaged units or floor-ducted splits in the manufactured homes. On a large house the long duct run is the thing worth examining: the further a run goes across a hot attic, the more likely its insulation has failed somewhere along it, and a section of duct condensing over a ceiling produces a stain with no plumbing anywhere near it.
The reason that matters is a gap between two numbers, both from the Florida Solar Energy Center at the University of Central Florida. Through the hot months, with cooling running, indoor relative humidity should not exceed 55% during the day on a regular basis. And the great majority of mold species need a material moisture content corresponding to a relative humidity of at least 70% to grow at all.
Note where that second number is measured. Not in the room. At the material. Air holds less moisture as it cools, so the film of air against a chilled surface sits at a far higher relative humidity than the room average. A wall at 68F with 78F room air at 55% is close to saturation at its own face, and it does not need a leak to get there. That is the mechanism behind almost every complaint where nobody can find a source.
So in Davie we read surface temperatures with an infrared thermometer alongside the room air, calculate the dew point of that air, and record the margin at every surface that has one worth recording. FSEC also give the point at which cooling alone stops being enough: sustained readings of 70 to 75% mean dehumidification rather than a colder thermostat, and turning the thermostat down at that stage chills the surfaces further and makes it worse.
The commercial position in Davie is the one published on every page of this site, because the rate card is not a Fort Lauderdale rate card. A flat price by property size, agreed before anyone drives out, with the accredited laboratory fee already inside it. It does not rise if the samples come back positive, nothing is added for the drive, and we take no payment of any kind from anyone who removes mold.

What Davie itself changes
The buildings in Davie
Davie carries 41,755 units at a 1989 median, and the headline number hides an unusually wide spread. Forty per cent is single-family detached, much of it on large lots in the town's long-standing equestrian districts, while 13.7% is manufactured housing, the second-highest share in the county. Those two building types have almost nothing in common: one is a site-built slab house on an acre, the other a raised floor assembly over bare ground. An inspection approach designed for either is wrong for the other, and Davie has plenty of both.
Where the water comes from
The town runs west to the Everglades boundary, and the western parts sit on land where the water table is close to the surface and managed by canal rather than by drainage away. On a large lot in that position, landscape irrigation, a pool and the natural table together keep the ground around a building damp through most of the year, which narrows the margin on a slab edge and on any part of a structure close to grade. Private wells and septic systems are present in parts of the town.
Where it hides in these buildings
Two different inspections. On a site-built house it is the ordinary Broward survey with extra attention to the slab edge and to any additions. On a manufactured home the work runs underneath: belly wrap, floor insulation, ground condition and the ventilation of the void. Large-lot properties also frequently carry outbuildings, guest accommodation or converted stables, and those are habitually left out of an inspection brief until somebody asks.