What the equipment in Tamarac can and cannot remove
Split systems with the air handler in a utility closet or the garage, and in a single-storey villa the condensate route is often short and shallow, which is exactly the geometry that fails. A line with insufficient fall does not clear itself, and the biological growth that closes these pipes every wet season has an easier time in a run that does not drain hard. On a seasonal property nobody is present when the pan overflows, which is how a small failure becomes a floor.
The reason that matters is a gap between two numbers, both from the Florida Solar Energy Center at the University of Central Florida. Through the hot months, with cooling running, indoor relative humidity should not exceed 55% during the day on a regular basis. And the great majority of mold species need a material moisture content corresponding to a relative humidity of at least 70% to grow at all.
Note where that second number is measured. Not in the room. At the material. Air holds less moisture as it cools, so the film of air against a chilled surface sits at a far higher relative humidity than the room average. A wall at 68F with 78F room air at 55% is close to saturation at its own face, and it does not need a leak to get there. That is the mechanism behind almost every complaint where nobody can find a source.
So in Tamarac we read surface temperatures with an infrared thermometer alongside the room air, calculate the dew point of that air, and record the margin at every surface that has one worth recording. FSEC also give the point at which cooling alone stops being enough: sustained readings of 70 to 75% mean dehumidification rather than a colder thermostat, and turning the thermostat down at that stage chills the surfaces further and makes it worse.
The commercial position in Tamarac is the one published on every page of this site, because the rate card is not a Fort Lauderdale rate card. A flat price by property size, agreed before anyone drives out, with the accredited laboratory fee already inside it. It does not rise if the samples come back positive, nothing is added for the drive, and we take no payment of any kind from anyone who removes mold.

What Tamarac itself changes
The buildings in Tamarac
Tamarac carries 34,141 units at a 1981 median with 76% owner occupancy, and a large part of that is single-storey villa and duplex housing built for over-55 communities. The buildings are modest, well-built for their date and share a set of characteristics that are unusually consistent: low-slope or shallow-pitched roofs, small attics or none at all, party walls between paired units, and interior layouts with limited air movement between rooms. Consistency helps an assessment considerably, because a property behaving unlike its neighbours is saying something.
Where the water comes from
The seasonal pattern is the water story here as it is in Deerfield Beach, though it arrives differently. In a villa rather than a condominium the owner usually leaves the property closed rather than the building managing it, and the thermostat gets set high or the system switched off entirely. Through the six months from May to October that carry 47.27 of the annual 66.52 inches, with dew points in the low seventies, that produces a building that has been equalising with outdoor air for a season.
Where it hides in these buildings
Party walls between paired villas are the specific thing to check in Tamarac, because a condensate failure or a plumbing leak on the neighbour's side appears on yours with no visible source at all. Establishing direction of travel across a shared wall is a metering exercise on a grid rather than a visual one, and it is the finding that decides a conversation between two owners who are usually on good terms and both baffled.